How to install the NEW NFORCE 4 drivers?

  • Thread starter Thread starter Christian
  • Start date Start date
C

Christian

Hi I got Windows VISTA 64bit, and i cant get the new sata driver (non-RAID)
to work....
which entry would i have to select if i would take the manual way over inf
installation?

the only entries i have in the Device manager are the following:

in
IDE ATA/ATAPI Controller
ATA Channel 0
ATA Channel 0
ATA Channel 1
ATA Channel 1
Standart-Dual-Channel PCI-IDE Controller
Standart-Dual-Channel PCI-IDE Controller

once i managed that NFORCE SATA controller appeared in this list but it was
marked as not working ;(((

Btw. i have got this sysconfig:
64-bit AMD CPU
2 Gig Corsair
Only SATA Channels 1 and 2 are active the 2 others are not needed atm and
disabled in bios->tried to activate, didnt solve the problem
2 CD-Rom Drives on serpate IDE-cables each configed as Master..
NFORCE 4 Ultra Chipset /ASUS a8ne w/o SLI
 
I think i managed it

just took the other StandartDualChannel entry and manually installed from
/nvidia/ide_sata folder, hope it will run after restart in SATA mode, until
now it runs in PIOmode ;(
 
Now my SATA Samsung sp2004c shows up as sp2004c SCSI device in device
manager ?? what means that? i got no raid enabled or raid software installed
as far as i know^^
 
No jew here that can answer this? than fock jew
Christian said:
Now my SATA Samsung sp2004c shows up as sp2004c SCSI device in device
manager ?? what means that? i got no raid enabled or raid software
installed as far as i know^^
Click to expand...
 
Back
Top