How do I get my ATI 9600 TX to work with Vista

  • Thread starter Thread starter Charles
  • Start date Start date
C

Charles

All I get is that it installed fine, but the device wont start....

Thia is what I get in Properties:
"Windows has stopped this device because it has reported problems. (Code
43)"

I have already let windows sort it from updates, but no joy, so I went to
the ATI site & downloaded the latest driver version that also said it was
for Vista, but still no joy....

I am now getting severe withdrawals from normally using my twin monitors...
:(

What gives...?
 
The latest driver version from the ATI website requires Vista RC2 or later
and may also require the latest BIOS update for your MOBO. Does your
installation satisfy both of these requirements and did you download the
corect drivers for your system OS either the 32 bit version(X86) or the 64
bit version?
 
Am using rtm... & the 32 bit drivers only, am on the latest bios too

The pre-install prog only moaned about norton av & Zonealarm when run from
XP, so I have neither installed on this clean vista install on a new
drive.... it didn't even remark on my ati card or driver...

it's just my luck....
 
Back
Top