Home networking question

  • Thread starter Thread starter Bill
  • Start date Start date
B

Bill

I have a cable modem. The place cable modem was hooked up is at one of the
corners of the house. I also have an ethernet network pre-wired in the
house. So I installed a D-Link wired router and feed one of the lines to the
wired network. I also installed a Linksys wireless router to one of the
wired network outlets at the center of the house. In such a way, I have good
reception of the wireless signal.

It works perfectly for computers on both networks to get on Internet. Now my
question is how to let the computers on these two networks talk to each
other? For example, I can ping the computers on wired network from the
computers on the wireless network. But not vice versa. I cannot share the
directories on computers on different networks. Thanks for your help.
 
I know very little about access point. My understanding is that Access Point
does not provide the function of a router. Does it act like a hub/switch
such that I can use multiple wireless devices with one access point? I have
bought the hardware. How can I configure my network ot make it work? I am
familiar with the networking theory. So you can throw me with all those
technical stuff. Thanks.
 
A access point allows you to use wireless network access to access the
network rather than using wired.

You simply plug the wireless access point into your switch/router and
install using the software.

and then you can use laptops with WiFi, or use wireless pci cards for pc's.

Hope this helps

Sam
 
Thanks for the reply. I would like to keep the wireless router since I may
use multiple wireless devices at the same time. My understandind is that I
need a router not an access point to do that. In that case, I have two
subnets.

Theoretically I need to let the computers on the wired network know that
traffic to the wireless subnet goes to the wireless router and the rest goes
to the router connected to the cable modem. So I need to add this
information to routing tables for those computers. But, I don't know how. Am
I on the right track? Thanks for your help.
 
Try this alternative...... A way to add the wireless router to your
network. You can also share files across networks by using the IP
addresses.
http://www.pccitizen.com/correctwireless.htm
John

Bill said:
I have a cable modem. The place cable modem was hooked up is at one of the
corners of the house. I also have an ethernet network pre-wired in the
house. So I installed a D-Link wired router and feed one of the lines to the
wired network. I also installed a Linksys wireless router to one of the
wired network outlets at the center of the house. In such a way, I have good
reception of the wireless signal.

It works perfectly for computers on both networks to get on Internet. Now my
question is how to let the computers on these two networks talk to each
other? For example, I can ping the computers on wired network from the
computers on the wireless network. But not vice versa. I cannot share the
directories on computers on different networks. Thanks for your help.
Click to expand...
--
Check my web site for tips on insuring safe computing in wired and wireless
homenetworking environments!
www.pccitizen.com
You spend your whole life figuring out what you should have done with it,
let alone what it was all about. And then your children get to do it all
over again.
 
Back
Top