C
Carlos Arruda
In my opinion i think that its this that we are missing and that after its
done i can use my router.
But the problem is that in the cd-rom that came with the router does not
have any flash software nor USB Drivers, although there's a folder named USB
Drivers and another one named XP but windows XP say that no drivers were
found on that location.
I have the following written on the router board.:
RTL8305SB
35065Q1
3200 Taiwan
RMC
Another one with the following.:
Conexant
AccessRuner
CX82310-14
E366878.1
0320 PHILIPINES
ARM
There is one jumper inside the unit as well but i shouldn't need it cause i
can reset the router from the outside by inserting a smal thin needle and
reset it.
2.1 Programing Flash Memory
Before accessing the web pages, the flash memory on the reference
board (What do you mean by this, no one else seems to know) must be
programmed using the Conexant USB Flash Utility (Where is it? In the cd that
came with the router there's nothing but USB Drivers folder and manual PDF)
where can i get this software?
1. Connect the reference board to a PC with the conexant USB
Flash Programmer installed.
2. Program the flash memory.
2.2 Reference Board Installation
Connect the ADSL Reference Board to the PC and ADSL line.
1. Connect the ADSL Reference Board to the PC LAN port with a
CAT-5 cable. Use straight cable for DL10-D320 Rev 2 board or a crossover
cable for DL10-D470 board.
2. Connect the ADSL Reference Board to the ADSL line to the ISP.
Any more ideas mates?
Thanks so much for the time spent with me with this subject.
Best Regards
Carlos Arruda
done i can use my router.
But the problem is that in the cd-rom that came with the router does not
have any flash software nor USB Drivers, although there's a folder named USB
Drivers and another one named XP but windows XP say that no drivers were
found on that location.
I have the following written on the router board.:
RTL8305SB
35065Q1
3200 Taiwan
RMC
Another one with the following.:
Conexant
AccessRuner
CX82310-14
E366878.1
0320 PHILIPINES
ARM
There is one jumper inside the unit as well but i shouldn't need it cause i
can reset the router from the outside by inserting a smal thin needle and
reset it.
2.1 Programing Flash Memory
Before accessing the web pages, the flash memory on the reference
board (What do you mean by this, no one else seems to know) must be
programmed using the Conexant USB Flash Utility (Where is it? In the cd that
came with the router there's nothing but USB Drivers folder and manual PDF)
where can i get this software?
1. Connect the reference board to a PC with the conexant USB
Flash Programmer installed.
2. Program the flash memory.
2.2 Reference Board Installation
Connect the ADSL Reference Board to the PC and ADSL line.
1. Connect the ADSL Reference Board to the PC LAN port with a
CAT-5 cable. Use straight cable for DL10-D320 Rev 2 board or a crossover
cable for DL10-D470 board.
2. Connect the ADSL Reference Board to the ADSL line to the ISP.
Any more ideas mates?
Thanks so much for the time spent with me with this subject.
Best Regards
Carlos Arruda