HDD's

  • Thread starter Thread starter Mr P nis
  • Start date Start date
M

Mr P nis

have 4 hdd's 2 on ide and 2 on raid ata 133 card_problem is I have to boot
twice at the start of a new day or when computer has been off for hours for
the ata 133 HDD's will show in my computer__am using a 600w PSU and have
tried another IDE ribbon cable__I have installed the raid IDE software but
have not configured it as all I need is the extra HDD's as a storage
area______thanking all
 
Mr P nis said:
have 4 hdd's 2 on ide and 2 on raid ata 133 card_problem is I have to boot
twice at the start of a new day or when computer has been off for hours
for the ata 133 HDD's will show in my computer__am using a 600w PSU and
have tried another IDE ribbon cable__I have installed the raid IDE
software but have not configured it as all I need is the extra HDD's as a
storage area______thanking all

2 recommendations.

Balance both sides of the output molex plugs from your power supply. It has
at least 2 sides.

If you use some form of power removal from the entire PC while its off (good
idea), energize this for at least 30 seconds before turning on the PC.
Dave
 
1__have the latest drivers Ver 1723
2__Balance both sides of the output molex plugs from your power supply ?
<what does this Mean !!
have had to increase the molex plugs to 7 as there were only 4 on the PSU
 
Firmware is not the same as drivers

Mr P nis said:
1__have the latest drivers Ver 1723
2__Balance both sides of the output molex plugs from your power supply ?
<what does this Mean !!
have had to increase the molex plugs to 7 as there were only 4 on the PSU
 
IF you're going to reply to me, reply to my post. Not your own post. Then,
I'll consider a reply.
Dave
 
I didnt reply to you, until now, and the contents of my reply (the msg I
replied to) shows that.
If I had replied to you your msg would have been topmost as it is here.
 
You obviously are unaware of the thread hierarchy in usenet. I wasn't
addressing you at all.
Dave
 
Back
Top