Hard works on USB but not on Firewire

  • Thread starter Thread starter Guest
  • Start date Start date
G

Guest

I have an Iogear ION Tri-Select hard disk. The drive works fine when I
connect via its USB connection. But when I connect by Firefire (IEEE 1394)
it does not work.
Under RC1 the device manager showed a driver error and would not let the
drive work.
Under RC2, the driver error is gone, but when asked to populate info on the
drive, it returns an error.

(1) How do I report the problem to Microsoft, so it is fixed
(2) Any suggestions on how to get the drive to wrok on the Firewire port?
 
There is an solutaion center and when you run it it asks if it should check
status and will let you know if it has been sent. you can also send any
reports that are not sent or provide additional information.

-Bob
 
Pgo said:
I have an Iogear ION Tri-Select hard disk. The drive works fine when I
connect via its USB connection. But when I connect by Firefire (IEEE 1394)
it does not work.
Under RC1 the device manager showed a driver error and would not let the
drive work.
Under RC2, the driver error is gone, but when asked to populate info on the
drive, it returns an error.

(1) How do I report the problem to Microsoft, so it is fixed
Click to expand...

Whe you've installed Vista, it places a feedback icon on your desktop.
Download the report utility and fill your report.
However there is too little time left to fix anything...

--PA
 
Back
Top