Getting Error: "The client could not connect to the remote compute

  • Thread starter Thread starter Gaser Nadeem
  • Start date Start date
G

Gaser Nadeem

Hello,

I've Windows Vista at my Office, and 2 Computers at my home. Both have
Windows XP SP2. I can connect from only one to my office's PC, but the other
one when I try to connect from it to my office's PC through Remote Desktop
I'm getting this error:
"The client could not connect to the remote computer.
Remote connection might not be enabled or the computer might be too busy to
accept new connection.
It is also possible that network problems are preventing your connection"

Any help will be appreciated
 
It could be a 3rd party software. Check the following link or start the
computer with clean boot.

The client could not connect to the remote computerSymptom: When trying to
access TS/RDC, you may receive this error: The client could not connect to
the remote computer. Remote connection might not be ...
www.chicagotech.net/remoteissues/rdc2.htm

Windows generalHow to run Windows OS with a clean boot · How to Run
Windows Safe Mode with Networking · How to setup DHCP for IP Phone How to
sort programs in Start ...
www.howtonetworking.com/Windows/windowsgeneral.htm



--
Bob Lin, MS-MVP, MCSE & CNE
Networking, Internet, Routing, VPN Troubleshooting on
http://www.ChicagoTech.net
How to Setup Windows, Network, VPN & Remote Access on
http://www.HowToNetworking.com
 
Back
Top