G
Guest
I have been using XP embedded now for a few months and have got a working EWF
RAM (Reg) protected image created using the Feature Pack 2007 Enhanced Write
Filter component. There is only one partition on the hard disk (C
. When I
enable HORM in Target Designer and include Hibernation support and rebuild
everything works as expected until I hibernate the system. After restartng,
the Resuming Windows screen appears and the progress bar increments until it
reacheds the end. At this point, when I would expect it to go into the XP OS
the computer just stops and stays stopped. I assume the HORM functionality is
working as it always tries to reboot from the hibernation file. Only
restarting it and using F8 to go for a full system boot allows me to get back
into XP. I have searched through the internet for help on this problem but
have so far drawn a blank. Has anyone experienced this using the Feature Pack
2007 components? If anyone could help or point me to an article which might
help me I would appreciate it a lot.
Thanks in advance
Lee Laming
RAM (Reg) protected image created using the Feature Pack 2007 Enhanced Write
Filter component. There is only one partition on the hard disk (C

enable HORM in Target Designer and include Hibernation support and rebuild
everything works as expected until I hibernate the system. After restartng,
the Resuming Windows screen appears and the progress bar increments until it
reacheds the end. At this point, when I would expect it to go into the XP OS
the computer just stops and stays stopped. I assume the HORM functionality is
working as it always tries to reboot from the hibernation file. Only
restarting it and using F8 to go for a full system boot allows me to get back
into XP. I have searched through the internet for help on this problem but
have so far drawn a blank. Has anyone experienced this using the Feature Pack
2007 components? If anyone could help or point me to an article which might
help me I would appreciate it a lot.
Thanks in advance
Lee Laming