Form Size

  • Thread starter Thread starter Walter Steadman
  • Start date Start date
W

Walter Steadman

Access 2003, WinXP

Greetings all,
When I am in design view of a Form, I can set the Form width to say 4" I
am creating a form with a Thin Border and I have said it cannot grow and
will be Auto Centered. But then I have to size the design box down around
the form to make it the right size. Is there a better way to do this or a
simpler way, as it seem when I have to resize the design area down to try to
be the size of the form, it is not exact. Is there a way to exact it? So
if I want the form to be 4" wide, it is 4" wide and not 4.25" or 3.875"?

TIA
 
Sorry about that, I got the answer after doing something I should have done
before posting, READING OTHER POSTS. I was just not looking at the right
posts.
 
Walter,

I may have a similar problem. What was your solution, if I may ask?

TIA.

Phil.
 
Set the AutoResize Property of the Form to Yes / True.
Save and close the Form (*important*).
Re-open the Form in Form mode.
 
Back
Top