Here are some possible causes:
Faulty Floppy Drive.
Floppy cable not connected correctly, of disconnected.
Incorrect CMOS settings.
Faulty floppy drive controller.
Shut down
Disconnect Floppy cables
Reboot into safe mode
remove floppy in system properties
Reboot
Shut down
Reconnect both cables ( power & data)
Reboot
You have a hardware problem! Because it is the least expensive, remove and
reinsert the cables to your floppy drive - both ends please. If no help
replace the ribbon cable.
If still no joy you have either a power problem or a faulty drive!
--
Regards,
Richard Urban
aka Crusty (-: Old B@stard
If you knew as much as you think you know,
You would realize that you don't know what you thought you knew!
Thanks for replies....Troubleshooter says all systems go!! drive works
OK....message on start up only query....press F1 or restart and pc acts as
normal...Regards Mardy
Thanks for replies....Troubleshooter says all systems go!! drive works
OK....message on start up only query....press F1 or restart and pc acts as
normal...Regards Mardy
Thanks for replies....Troubleshooter says all systems go!! drive works
OK....message on start up only query....press F1 or restart and pc acts as
normal...Regards Mardy
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments. After that, you can post your question and our members will help you out.