fbreseal problem with CF and SATA disks

  • Thread starter Thread starter Albert Torras
  • Start date Start date
A

Albert Torras

Hi all,

I used to perform fbreseal operations, working with Compact Flash
drive only, and everything worked just fine.

Now I am working with Compact Flash and SATA disks both in the same
board.

C: --> CF
D: --> SATA HD

When I go through the resealing phase, both units are changed. I've
tried -keepmounted parameter and even with -keepall, and results are
the same.

Anyone experienced the same? Anyone know how to solve it?

Thanks in advance
Albert
 
What do you have enabled and disable in the System Cloning Tool settings?

-Sean
 
Hi,

I have all options enabled in the System Cloning Tool settings... even
the one that reads: Remove Mounted Devices (such as network drives).

Is this bad? Should I rebuild the image with the option disabled?

I thought what -keepmounted did was to override that setting, at least
-autologon option works with fbreseal command.

Thanks for your help
Albert
 
Hi again,

I tested the system in the following way.

--->Built new image with Remove Mounted Devices (such as network
drives) option disabled.
--->Run FBA, Windows appears with my CF device as C unit only.
--->Connect SATA device, D unit appears.
--->Reboot, everything just fine, CF as C, SATA as D
--->fbreseal -keepall
--->After reseal phase, the same happens again, SATA as C, CF as D

I am completely lost.
Albert
 
Back
Top