fba.exe application error

  • Thread starter Thread starter Guest
  • Start date Start date
G

Guest

I'm trying to get a basic image working on a Lippert Lightrunner 2 PC/104
board.

I created components for all the drivers available from their site(graphics,
system,ethernet and audio). I created the component from the devices.pmq file
created using tap and deployed it to the target device.

A little past halfway through the "installing components" stage of FBA I get
the following error.

The instruction at "0x03672f5d" referenced memory at "0x0000000c". The
memory could not be read.

How can I go about figuring out the cause of this problem?
 
You should take a look at the "\windows\fba\fbalog.txt" file to see what's going on there.

Also, hope is that your image is not bit enough to not fit in your target device RAM. IF that's the case, enabling pagefile support,
if acceptable, can sometime be a cure.
 
Back
Top