FBA does not run once Image is copied to target...?

  • Thread starter Thread starter Guest
  • Start date Start date
G

Guest

My target is a Dell PowerEdge 2850 I had to modify my XPE Disk 1 to be able
to see the new LSI SCSI controller, once I got that done, I was able to copy
my image to the Target's HDD.

I also created a new component for the LSI SCSI controller in Component
Designer and added it to my image ( and I suppose this is where my problem
lies).

Once I reboot, the FBA does not even start, however all the files are on the
HDD, I can look at them if I boot with XPE Disk 1 again and look at my c:\
drive.

How can I find out if my SCSI driver is loaded or not?

TIA

Bernie
 
Bernie,

Add /SOS switch to your boot.ini to see what drivers are loaded.

Hope that your LSI component sets the start at boot phase for the driver.
If you are not sure what phase you shuold set set, analyze the controller driver parameters on XP Pro installed on the target
machine.

=========
Regards,
KM
 
KM thanks for your help.
I really had a brain-fart, I forgot to mark the partition as active when I
created it in SDI Loader, and this was whyit didn't boot.

Bernie
 
Bernie said:
KM thanks for your help.
I really had a brain-fart, I forgot to mark the partition as active when I
created it in SDI Loader, and this was whyit didn't boot.
Click to expand...
We've all done that... I still do it occasionally.
 
Back
Top