Failed to format the selected partition (Error: 0x80004005)

  • Thread starter Thread starter Guest
  • Start date Start date
G

Guest

I am attempting to install Windows Vista Beta 2 64 bit. I burned my DVD at
1x, without any reported problems. The DVD boots, and I reach the point where
I nominate the partition to format (there are currently no NTFS partitions on
the single SATA disk). I attempt to format it, and I get the error above. Any
clues?
 
Are you installing the SATA drivers prior to attempting to format? It maybe
that the operating system cannot see the SATA drive. I know SATA drives are
temperamental with Windows XP, so they are probably worse with Vista.

--
John Barnett MVP
Associate Expert
http://xphelpandsupport.mvps.org

The information in this mail is supplied "as is". No warranty of any kind,
either expressed or implied, is made in relation to the accuracy,
reliability or content of this mail. The Author shall not be liable for any
direct, indirect, incidental or consequential damages arising out of the use
of, or inability to use, information or opinions expressed in this mail..
 
i have the same problem, but windows vista can see my SATA, actually it
displays the Name, Total Size and Free Size of my SATA.

regards
alex
 
I haven't installed any additional drivers. Since the installer has
accurately read the partition table, what could usefully be additionally
loaded? Searching the Microsoft site for 0x80004005 suggests that it is a
catch-all error code, so it doesn't of itself give much of a clue.
 
I had 3 partitions on my SATA, i deleted one to install RC1 but when i tried
to format it it gave me error "error 0x800424f". this sounds similar. I will
try to reformat the entire drive and let you know if that worked.
 
Back
Top