External hard drive isn't acting right

  • Thread starter Thread starter Craigers
  • Start date Start date
C

Craigers

I bought a ready made Western Digital external drive which was already
partitioned as 114GB FAT32, and connect using 1394; works a treat and is
now full.

I then bought an ADS Tecnologies Pyro 1394 Drive kit and installed a
Maxtor 120 GB drive into it. The jumper was set on 'Master.' It was then
formatted as an NTFS partition.

When attempting video capture to this drive I am informed by that
software (Pinnacle) the write portion is not fast enough¹.

To check this out further, I attempted to move files from the HDD and
it is _noticably_ slower; and if it's a (largish) video file, it will
run but there is visible frame 'static.'.

I have have switching both 1394 cable ports on the pc box, as well as
daisy chaining into the other firewire device.

All indications from the W2K Computer Management consloe indicate the
device is working properly. Then why the slow speed?

1394 Adapter is a Linksys Model DFB-A5 USB 2.0/Firewire combo adapter,
and it works ok with other devices.

Any suggestions? Is there a way I can measure the transfer rate to see
if it is performing as designed?

I have conatacted ADSTech but it's only been a day and have little
confidence they will respond.

System:
OS is Windows 2000 SP4, PIII 1,000GHz, 512MB RAM.

--
Craig

1. The WD drive "reads 31222 kb/sec, writes 12041 kb/s"; the ADS "reads
25973 kb/s, writes 1091 kb/s" and "...is not capable of capturing DV
data." Ah.
 
1. The WD drive "reads 31222 kb/sec, writes 12041 kb/s"; the ADS "reads
25973 kb/s, writes 1091 kb/s" and "...is not capable of capturing DV
data." Ah.

Where did you get these figures? That factor of 10 difference in write speed
has to be the problem.

Try SiSoft Sandra for benchmarking S/W
 
Back
Top