Error when using requery action

  • Thread starter Thread starter Leonard Patella
  • Start date Start date
L

Leonard Patella

I have an form that has default view as continuous forms.
There is a command button that requeries the form though a
macro (Requery Action). I have converted this application
to an MDE.

Everything works fine on my pc. The problem is when I
move the application to other pc's and click the button, I
get a pop-up error message "Invalid object or no longer
valid" followed by another pop-up error message, "unknown
function name", then the application crashes.

I cannot understand why it works on some pc's and not
others. All are running Access 2000. The same problem
occurs with the MDB.

Any suggestions?????
 
I have an form that has default view as continuous forms.
There is a command button that requeries the form though a
macro (Requery Action). I have converted this application
to an MDE.

Everything works fine on my pc. The problem is when I
move the application to other pc's and click the button, I
get a pop-up error message "Invalid object or no longer
valid" followed by another pop-up error message, "unknown
function name", then the application crashes.

I cannot understand why it works on some pc's and not
others. All are running Access 2000. The same problem
occurs with the MDB.

Any suggestions?????
Click to expand...
--------------------
Since the error occurs on both the MDB and MDE versions of your
application, that eliminates the possibility of a bad or corrupt MDE. The
most likely cause is a bad Access install.

Check the versions of Access on the machines. Compare the "good" PCs and
that "bad" ones. Perhaps the bad ones need a service pack or service
release.

Hope this helps,
 
Back
Top