Error in Hardware monitor in P4PE

  • Thread starter Thread starter JuanJo Alaiza
  • Start date Start date
J

JuanJo Alaiza

After 1 hour or more with mains off (with PS switch) the BIOS send a
hardware error mesage with indication to go a hardware monitor

F1 for continuing boot or Del for go to setup

In Hadrware monitor not indicate any trouble.

If continuing boot is achieved normaly.

If shuts down the computer (without mains off) or mains off fewer
minutes, the booting is normal.

Any ideas??

Saludos
Juan Jose Alaiza
Barcelona
Catalunya
Espanya

jjalaiza arroba apexmail punto com
 
Hello JuanJo,
I've had my P4PE about 3 days. I have noticed if my case fan speed drops
below 1500rpm it will do what you described when booting. My case fan is
controlled by my power supply so the speed will vary with temp. Could be
your power supply fan speed also. Easy to check. The speed in the BIOS
hardware monitor will be in red. I don't know what minimum speeds are for
this board. Perhaps some one here will know. This is one place to check.
Click to expand...
Thanks.

I investigate.

Saludos
Juan Jose Alaiza
Barcelona
Catalunya
Espanya

jjalaiza arroba apexmail punto com
 
Back
Top