error executing command

  • Thread starter Thread starter Mark Kubicki
  • Start date Start date
M

Mark Kubicki

this is happening A LOT to me lately, and I'm getting VERY frustrated...

I edit a form (in design view) and then go to look at it in form view, or
close it and try to reopen it... and i get this warning notice:

THERE WAS AN ERROR EXECUTING THE COMMAND
(comapct and repair does not help.)


anmy hints about what's going on !?!?!?!? (i'm loosing a lot of time having
to re-edit (to the point where i make a back-up every 1/2 hour !!!)


(obviously) not happy,
Mark
.... as always, thanks in advacne
 
Mark,

What version of Access are you using? Is there code behind your form? If
so, posting it would be helpful.

Bob
 
version 2003 SP1, and yes there is code behind the form... (about 20 or 30
printed pages worth of it... might be allot to post)

also, did I mention that I can't open the form is design view either
(however, I can get to the code)
 
Back
Top