error checking

  • Thread starter Thread starter Felix Nepveux
  • Start date Start date
F

Felix Nepveux

Every time I start windows I get a message that the disc
is being checked, but that the error checking program can
not get exclusive use of the drive. When I really try to
do a disc check it does not work the next time I start
windows, I get the same message as when I start up
normally, with no previous request to do a disc check.
 
If you get an error something to the effect "cannot open volume for direct
access" There is some system/boot start device that is reading/writing to
the drive before chkdsk can get a lock on the drive. Some anti-virus
applications do this.

You can also run
chkdsk /r
from the recovery console command line. (/r implies /f and /p)

To start the Recovery Console, start the computer from the Windows 2000
Setup CD or the Windows 2000 Setup floppy disks. If you do not have Setup
floppy disks and your computer cannot start from the Windows 2000 Setup CD,
use another Windows 2000-based computer to create the Setup floppy disks.
Press ENTER at the "Setup Notification" screen. Press R to repair a Windows
2000 installation, and then press C to use the Recovery Console. The
Recovery Console then prompts you for the administrator password. If you do
not have the correct password, Recovery Console does not allow access to the
computer. If an incorrect password is entered three times, the Recovery
Console quits and restarts the computer. Note If the registry is corrupted
or missing or no valid installations are found, the Recovery Console starts
in the root of the startup volume without requiring a password. You cannot
access any folders, but you can carry out commands such as chkdsk, fixboot,
and fixmbr for limited disk repairs. Once the password has been validated,
you have full access to the Recovery Console, but limited access to the hard
disk. You can only access the following folders on your computer:
%systemroot% and %windir%

--
Regards,

Dave Patrick ....Please no email replies - reply in newsgroup.
Microsoft Certified Professional
Microsoft MVP [Windows]
http://www.microsoft.com/protect


:
| Every time I start windows I get a message that the disc
| is being checked, but that the error checking program can
| not get exclusive use of the drive. When I really try to
| do a disc check it does not work the next time I start
| windows, I get the same message as when I start up
| normally, with no previous request to do a disc check.
 
Back
Top