Epson Colour 680 Cartridge Re-programer

  • Thread starter Thread starter Vic
  • Start date Start date
V

Vic

After re-inking the colour cart' and using the re-setter, until the light
flashes about 1 per sec the cartridge was installed as per sequence. However
the printer does not recognise the "new" cart'. Using a compatible is OK.
Never had this problem before when using my reprogram device. Any ideas
welcome Vic
 
Think I might have found the reason. I use an adhesive foil to seal the
nozzles while filling. This is applied on top of the manufactures seal. I
ask the question .. could this extra thickness make the chip contact wires
out of register with the chip segments? Any experience out there ?
Regards Vic
 
Back
Top