R
railserver R-3
Can't get defrag to work, keeps showing "Please run Chkdsk /f"
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
D
David B.
So have you tried the obvious solution, run chkdsk /f?
S
Singapore Computer Service
Hello,
Click on Start > Run > Chkdsk /f > OK
You will most likely need to restart your computer. Restart your computer,
let CHKDSK do its work and once it is started up again, you should be able
to run Defragmenter.
Although the risk of running CHKDSK damaging your hard drive is very low, it
is a good idea to have some kind of backup handy just in case.
__
http://www.bootstrike.com/ComputerService/
Singapore Computer Home Remote On-Site Repair Service
http://www.bootstrike.com/VHSVideoConvert/
Video Conversion VHS Video8 Hi8 Digital8 MiniDv NTSC PAL
Click on Start > Run > Chkdsk /f > OK
You will most likely need to restart your computer. Restart your computer,
let CHKDSK do its work and once it is started up again, you should be able
to run Defragmenter.
Although the risk of running CHKDSK damaging your hard drive is very low, it
is a good idea to have some kind of backup handy just in case.
__
http://www.bootstrike.com/ComputerService/
Singapore Computer Home Remote On-Site Repair Service
http://www.bootstrike.com/VHSVideoConvert/
Video Conversion VHS Video8 Hi8 Digital8 MiniDv NTSC PAL
R
railserver R-3
How or where do I run it from? not up to date on computers
D