cusl2 ver 1.02 motherboard

  • Thread starter Thread starter James
  • Start date Start date
J

James

Can anyone help please.

I have a "cusl2 ver 1.02" motherboard which for some reason it does not have
any pins in the area marked as "panel" section of the board where you would
connect things like the harddrive lights/pc speaker/rest button/soft power
switch.

According to the PDF maunal, the plugs for the rest switch & soft power
switch should connect to a set of pins near a lable called "panel", these
pins are missing and instead i have a set of pins called "vpanel", can
anyone tell me how I can connect the power switch & hard drive lights
please.

Thanks

James
 
Can anyone help please.

I have a "cusl2 ver 1.02" motherboard which for some reason it does not have
any pins in the area marked as "panel" section of the board where you would
connect things like the harddrive lights/pc speaker/rest button/soft power
switch.

According to the PDF maunal, the plugs for the rest switch & soft power
switch should connect to a set of pins near a lable called "panel", these
pins are missing and instead i have a set of pins called "vpanel", can
anyone tell me how I can connect the power switch & hard drive lights
please.

Thanks

James
Click to expand...

I have the same board. You must have a set of 10 double pins in the
corner of the board under all the PCI slots where the ATX power, reset
etc are connected. It does show it in the PDF document as you said,
and it is also on the board!

MarkS
 
Mark

Normally there are the set of 10 double pins BUT
on this board the pins are not fitted and on the PDF manual
there is no mention of a VPanel, I have a vpanel located
about 2mm above were the set of 10 double pins should be.
but they are not wired the same as the normal set of 10 double pins.

I've built about 10 pc's using gigabyte & Abit boards
but have never seen anything like this before

I'll gladly send you a picture :o)

James
 
Back
Top