creating run-time image

  • Thread starter Thread starter dan
  • Start date Start date
D

dan

I followed all the steps necessary to create a run-time
image to a different harddrive within Target Designer, but
for some reason when I try to boot with that Hard Drive, I
keep getting a "NTLDR is Missing, Press key to restart"
prompt on bootup. Any ideas?
 
Hi Dan,

Make sure the partition you are booting from is Active. Also, make sure you
are building your run-time image for the appropriate drive letter/ARC path.
Verify that the target settings for your run-time image are accurate. These
are located in the <component>.sld node under Settings.

Hope this helps
Dan
 
Hi

switch build type from debug to release



-----Original Message-----
Hi Dan,

Make sure the partition you are booting from is Active. Also, make sure you
are building your run-time image for the appropriate drive letter/ARC path.
Verify that the target settings for your run-time image are accurate. These
are located in the <component>.sld node under Settings.

Hope this helps
Dan

--
This posting is provided "AS IS" with no warranties, and confers no rights.




.
Click to expand...
 
Back
Top