Connecting a SATA and IDE drive to MB

  • Thread starter Thread starter mnitin73
  • Start date Start date
M

mnitin73

I have bought a new Seagate SATA drive as my system was very slow due
to hard drive problem. However, I want to continue using the older hard
drive as a additional storage. I installed windows on the SATA drive
and both are connected as masters. But the startup is still slow as it
takes time to detect the older drive. Advice on following - I have one
IDE drive, one SATA drive and a DVD-CDRW combo drive. The MB has one
IDE slot and 4 SATA slots. I want to boot from the SATA drive. What is
the best way of connecting them including whether to make them master
/slave/primary/secondary etc. Thanx
Nitin
 
I have bought a new Seagate SATA drive as my system was very slow due
to hard drive problem. However, I want to continue using the older hard
drive as a additional storage. I installed windows on the SATA drive
and both are connected as masters. But the startup is still slow as it
takes time to detect the older drive. Advice on following - I have one
IDE drive, one SATA drive and a DVD-CDRW combo drive. The MB has one
IDE slot and 4 SATA slots. I want to boot from the SATA drive. What is
the best way of connecting them including whether to make them master
/slave/primary/secondary etc. Thanx
Nitin
Click to expand...

(P)IDE:
old hard drive - master
DVD combo - slave

Make sure these devices are jumpered as such, namely:
old hard drive - master with slave present
combo - slave

If BIOS still takes a long time to detect the old hard drive, test it
with the manufacturers software.
 
Back
Top