Connect to not working

  • Thread starter Thread starter ldb
  • Start date Start date
L

ldb

In Vista home premium, if I click on the Start/Connect to button, nothing
happens. This appears to be a broken shortcut. Can this app be manually
called up by an exe file? How could this broken shortcut be fixed? I am
having trouble using the built in wireless NIC and an plug in wireless G card
to connect to wifi. This computer is not connected to a router. Both NIC's
appear with red x's. The internal NIC IS turned on via the Gateway mobility
center.
 
Hi
The wire connection need to be connect to something with a wire in order to
have viable connection.
The Wireless need a valid Wireless source, usually a Wireless Router.
What exactly you have that you want to connect to.
Jack (MS, MVP-Networking).
 
This computer used to show networks that it could connect to wirelessly such
as many of the free internet access sites in restaurants without encryption.
It now does not with either the built in wireless NIC or a plug in notebook
wireless NIC that Vista loads drivers for. The internal wireless NIC IS
turned on. When viewing the devices in the networking part of control panel,
it says that wireless networks are available and when you try and connect,
none show up in where the available list would be. Wired connections work
fine. In the TCPIP properties, it says to obtain an IP address. Both NIC's
show up in device manager and report to be working properly. Using the
diagnostic repair tool just brings you full circle to where you were.
 
Well go figure, the button and the other connect to links suddenly started
working again. The built in NIC also is working and available wireless
networks were visible and I could connect to them. I did nothing , it just
started working. Thanks for any help, this was my 2nd post and I worked for
hours on this about a week ago with no results.
 
Back
Top