connect to internet

  • Thread starter Thread starter rino
  • Start date Start date
R

rino

Hi,
If I have a RRAS server with 3 lan cards:

1 Lan card connected to my private lan ("LAN")
2 Lan card connected to internet by router A ("WAN")
3 Lan card connected to internet by router B and another provider ("WAN2")

I would like configure RRAS in this way:
LAN navigate by WAN for address type 80.80.100.0 sub 255.255.255.0 (example)
and for all rest of traffic using WAN2...

it's possible? how do I configure IGMP and NAT ?

thank's a lot
 
You should not need to configure NAT on this machine. I would expect
the other routers (at A and B) to be doing NAT if that is required.

You would configure RRAS as a LAN router. Set the LAN clients to use the
IP address of card 1 as their default gateway. Make sure the default gateway
for the RRAS machine's LAN NIC is blank. From the RRAS console, set the
default route to go to routerB via card 3. Then define a static route to
direct traffic for 80.80.100.0/24 to card 2.
 
Ok, Thank's....
But about IGMP ? How do I configure It ? I can set only one card as
proxy.....
sorry for my question but I don't know very well how IGMP works.....
thank you..
 
Back
Top