Closing

  • Thread starter Thread starter Guest
  • Start date Start date
G

Guest

When trying to add titles to Movie Maker 2.0 the whole program abruptly closes, resulting in me having to load the program again, only to find that once again when trying to add effects or titles the program just closes down. Without error messages, warnings or any sound

Is there anything I can do about this, as I used to use Movie Maker 1 and it was fine

Chris
 
Chris,

This is a fairly common issue. Check the Problem Solving > Acceleration and
Codecs page of my website.
--
PapaJohn
Movie Maker 2: www.papajohn.org
PhotoStory 2: www.photostory.papajohn.org
..
..
Chris_Stone said:
When trying to add titles to Movie Maker 2.0 the whole program abruptly
Click to expand...
closes, resulting in me having to load the program again, only to find that
once again when trying to add effects or titles the program just closes
down. Without error messages, warnings or any sound.
 
Hi there,

Your problem may be caused by a codec that Movie Maker does not like. This
a very common issue.

Your one-stop-don't-need-to-look-anywhere-else Solution is with a program
called "Rename Codecs".

Instead of reading miles of dross that is full of maybe's and perhaps's
just run the program, it takes a few moments to identify all of the known
codecs that cause this problem and gives you the opportunity of renaming
them, or, you can now use the new Auto feature in version 1.5 and let the
program take care of virtually everything to do with this problem

You can then run Movie Maker and immediately determine if it actually was a
codec issue. If it was a codec issue Movie Maker will now run properly. If
it was not the issue, you have lost nothing more than a short amount of
time.

Whether or not it was a codec issue you must run the program once more and
restore the problem codecs to their original names.

The two procedures together can take less time than it did to read this
message and a whole lot less than reading mountains of bumph that may or
may not apply to you.

The program "Rename Codecs" is free and available from my website.

While there it would be a good idea to check out the tutorial on how to run
the program...that will take around one minute of your time!!! Use this
quick link to get there real fast http://tinyurl.com/3ewb9

--
Best Wishes.....John Kelly
www.the-kellys.org
www.the-kellys.co.uk
All material gained from other sources is duly acknowledged. No Value is
obtained by publishing in any format other peoples work
 
Back
Top