Cisco VPN Client 4.8.01.0410

  • Thread starter Thread starter Hal9000
  • Start date Start date
H

Hal9000

I installed the cisco client for windows vista (4.8.01.0410).
Apparently it works, at first... it works for a couple of minutes, then the
connection seems to die completelly (no communication).
Only solution is to disconnect and reconnect vpn, then it works again for
another couple of minutes.
Anyone has had similar problems and perhaps knows of a solution=
Greets
hal
 
Hal9000 said:
I installed the cisco client for windows vista (4.8.01.0410).
Apparently it works, at first... it works for a couple of minutes, then
the connection seems to die completelly (no communication).
Only solution is to disconnect and reconnect vpn, then it works again for
another couple of minutes.
Anyone has had similar problems and perhaps knows of a solution=
Greets
hal
Click to expand...


I get the messages of a TrueVector Driver not being compatibile with Vista,
but all other works fine. I was connected yesterday to my office for view
hours with no problems.



Best regards
Chrtistopher
 
Hmmm.. just installed Cisco on a fresh Vista 5536 pre-RC1.
Installation went fine, no errors whatsoever.
VPN Client connects fine, but connection almost immediatelly dies. I need to
disconnect VPN to be able to use the internet again (via proxy, so only
limited to http/ftp protocol...)
Is there a newer vpn client version out there perhaps? I have 4.8.01.0410...
hal

<DIV>&quot;Krzysztof Mazurek&quot; &lt;[email protected]&gt; wrote in
 
Back
Top