If a volume's dirty bit is set, this indicates that the file system may be
in an inconsistent state. The dirty bit can be set because the volume is
online and has outstanding changes, because changes were made to the volume
and the computer shutdown before the changes were committed to disk, or
because corruption was detected on the volume. If the dirty bit is set when
the computer restarts, chkdsk runs to verify the consistency of the volume.
When Autochk runs against a volume at boot time it records its output to a
file called Bootex.log in the root of the volume being checked. The Winlogon
service then moves the contents of each Bootex.log file to the Application
Event log. One event log message for each volume checked is recorded. So
check the application event log.
If you get an error something to the effect "cannot open volume for direct
access" There is some system/boot start device that is reading/writing to
the drive before chkdsk can get a lock on the drive. Some anti-virus
applications do this.
You can also run
chkdsk /r
from the recovery console command line. (/r implies /f and /p)
To start the Recovery Console, start the computer from the Windows 2000
Setup CD or the Windows 2000 Setup floppy disks. If you do not have Setup
floppy disks and your computer cannot start from the Windows 2000 Setup CD,
use another Windows 2000-based computer to create the Setup floppy disks.
Press ENTER at the "Setup Notification" screen. Press R to repair a Windows
2000 installation, and then press C to use the Recovery Console. The
Recovery Console then prompts you for the administrator password. If you do
not have the correct password, Recovery Console does not allow access to the
computer. If an incorrect password is entered three times, the Recovery
Console quits and restarts the computer. Note If the registry is corrupted
or missing or no valid installations are found, the Recovery Console starts
in the root of the startup volume without requiring a password. You cannot
access any folders, but you can carry out commands such as chkdsk, fixboot,
and fixmbr for limited disk repairs. Once the password has been validated,
you have full access to the Recovery Console, but limited access to the hard
disk. You can only access the following folders on your computer:
%systemroot% and %windir%
This article may also help.
http://support.microsoft.com/default.aspx?scid=kb;[LN];160963
--
Regards,
Dave Patrick ....Please no email replies - reply in newsgroup.
Microsoft Certified Professional
Microsoft MVP [Windows]
http://www.microsoft.com/protect
:
| How do I stop "chkdsk" from running every time Windows
| 2000 boots? It will not run do to another application
| that is running, so I just want to disable it.
|
| Thanks,
|
| Dave
