changing the default routing

  • Thread starter Thread starter Guest
  • Start date Start date
G

Guest

I tried to setup my W2k server as a routing server.
I had 2 LAN cards installed under my server with 2 different network and I would like to utilise the router rip or OSPF routing and how should I do?By default I think it is using static route?
 
RRAS supports RIP and OPSF. They are not installed by default. You
install them from the RRAS console. In the IP routing section, right-click
General.

jenson said:
I tried to setup my W2k server as a routing server.
I had 2 LAN cards installed under my server with 2 different network and
Click to expand...
I would like to utilise the router rip or OSPF routing and how should I
do?By default I think it is using static route?
 
hi ,thks for the reply
once enable the RRAS and without adding the routing protocol such as OSPF.The routing were succesfull and how do I make use of it the OSPF routing
 
That's a bit harder. Start by reading up on OSPF in the help files.

jenson said:
hi ,thks for the reply.
once enable the RRAS and without adding the routing protocol such as
Click to expand...
OSPF.The routing were succesfull and how do I make use of it the OSPF
routing.
 
Back
Top