CDRW INSTALLED PC LOCKS UP

  • Thread starter Thread starter 1tek4u
  • Start date Start date
1

1tek4u

IBM CLONE, XP HOME 1 HD, 1 FLOPPY, 1 CDRW. cdrw stops responding, it
will not load/run any cd. I installed a new cdrw drive on IDE 2,
jumpered as Master. PC takes 5 minutes to boot, says new hardware
found once I get to desktop, PC/Mouse is frozen at this point. I
configured as a slave and cable with HD - reboot - same problem.
Checked the BIOS drive is reconized on IDE2 - Master. Any Idea's would
be appreciated. Thx Tek
 
IBM CLONE, XP HOME 1 HD, 1 FLOPPY, 1 CDRW. cdrw stops responding, it
will not load/run any cd. I installed a new cdrw drive on IDE 2,
jumpered as Master. PC takes 5 minutes to boot, says new hardware
found once I get to desktop, PC/Mouse is frozen at this point. I
configured as a slave and cable with HD - reboot - same problem.
Checked the BIOS drive is reconized on IDE2 - Master. Any Idea's would
be appreciated. Thx Tek
Click to expand...

Perhaps it's a problem with the IDE2 interface. Did you reuse the old IDE
cable when you installed the new drive? Try a new cable. Perhaps try a
different power connector? If that doesnt work try installing it as a slave
on IDE1?
 
I did configure as slave to IDE1 with HD - same problem, I did replace
the cable - same problem. Idea's ?
 
(e-mail address removed) wrote
IBM CLONE, XP HOME 1 HD, 1 FLOPPY, 1 CDRW. cdrw stops
responding, it will not load/run any cd. I installed a new cdrw drive
on IDE 2, jumpered as Master. PC takes 5 minutes to boot,
Click to expand...

Thats likely significant.
says new hardware found once I get to
desktop, PC/Mouse is frozen at this point.
Click to expand...

How long did you wait ?
I configured as a slave and cable with HD - reboot - same
problem. Checked the BIOS drive is reconized on IDE2 - Master.
Click to expand...
I did configure as slave to IDE1 with HD - same problem,
I did replace the cable - same problem.
Click to expand...
Any Idea's would be appreciated.
Click to expand...

Looks like its got a problem with the boot drive or the controller.

Post the SMART data for the boot drive using Everest.
http://www.majorgeeks.com/download.php?det=4181
Thats under Storage/SMART
 
Previously said:
IBM CLONE, XP HOME 1 HD, 1 FLOPPY, 1 CDRW. cdrw stops responding, it
will not load/run any cd. I installed a new cdrw drive on IDE 2,
jumpered as Master. PC takes 5 minutes to boot, says new hardware
found once I get to desktop, PC/Mouse is frozen at this point. I
configured as a slave and cable with HD - reboot - same problem.
Checked the BIOS drive is reconized on IDE2 - Master. Any Idea's would
be appreciated. Thx Tek
Click to expand...

Does the problem goe away if you do not have any CD drive in the
system?

Arno
 
Back
Top