CAT 3.9Drivers=no LCD monitor

  • Thread starter Thread starter peter
  • Start date Start date
P

peter

using an ASUS A7N8Xdeluxe ver 2.0 mobo and a ATI radeon 9600 pro with a NEC
LCD 1760nx.
I unistall the 3.8 drivers from within control panel/add&remove
I reboot and install the 3.9 drivers
upon rebooting I get as far as the XP start screen when the box comes up
that says no DVI#2 connection and my monitor goes to sleep.
I can get into safe mode 1 out of 10 times before this happens again.
I can power down and reboot and get into XP before it happens again.
Am I missing something????
TIA
peter
 
Try installing an analogue lead and see if you can get into windows, then
select DVI from display properties.
I'm using Samsung 181T with a 9800XT and 3.9's installed OK.
 
I have both an anlogue and digital monitor.
If I hook up the analoque one I have no problems.But I use this one on
another system
It only occures on the digitaly connected LCD monitor.
This LCD Monitor also has an anlogue connection so can I hook this monitor
up with both analogue and digital at the same time??? or would I damage
something???
tia
peter
 
That's what I meant Peter, connect the analogue lead to the LCD (not another
monitor).

Usually you can have both plugged in, I have done this procedure with two of
my LCDs with no problems, check in your manual to make sure there are no
particlular problems doing it with yours.
 
thanks
peter
Mark said:
That's what I meant Peter, connect the analogue lead to the LCD (not another
monitor).

Usually you can have both plugged in, I have done this procedure with two of
my LCDs with no problems, check in your manual to make sure there are no
particlular problems doing it with yours.


with comes
Click to expand...
 
Back
Top