Can't install RC1 or RC2 on RAID 0 -->nForce 3

  • Thread starter Thread starter Guest
  • Start date Start date
G

Guest

Vista does not recognize my RAID 0. I tried the XP driver but it doesn't work.
I've two Samsung 74GB S-ATA hard disks. Setup shows only one hard disk.

chipset: nForce 3-250

What can i do?
 
I have read what drivers are in the nForce3 package and
there is no SATA or RAID drivers mentioned. That would tend
to lead me to think there is some other controller chip on
your board that needs a different driver - perhaps Silicon
Image?
 
I've a Biostar 210P Barebone. Its definitively nForce3.

Raid is avtive.
Now Windows XP is installed on my Raid.
 
You will need to wait until such time as NVIDIA decides to release raid
based drivers for Windows Vista to the OEMs so the OEMs can tweak them to
their own specifications. This assumes of course that NVIDIA will decide to
do this for the Nforce 3 chipsets. I was running raid 0 myself but Vista
builds 5600 and 5728 would not work so I disabled the raid and I am just
running a normal SATA drive now with build RC2 5744 which works very well.

regards
Robert
 
I had seen where some of the nForce3 boards used other
controllers for SATA so I thought it might be worth checking
out.
 
Back
Top