G
Guest
The instructions goes like this:
------------------------------------------------------------------------------------------------
To capture the entire video from a tape in a DV camera
Make sure your DV device is connected properly to an IEEE 1394 port, and
then set the camera mode to play recorded video (often labeled VTR or VCR on
a DV camera).
On the File menu, click Capture Video.
–or-
In the Movie Tasks pane, under Capture Video, click Capture from video
device.
On the Video Capture Device page, in Available devices, click the DV camera.
In the Enter a file name for your captured video box, enter a file name for
your captured video file. Then, in the Choose a place to save your captured
video box, select the location where you want your video to be saved or click
Browse to select a location.
On the Video Setting page, choose the video setting you want to use for
capturing video and audio.
On the Capture Method page, click Capture the entire tape automatically.
The tape in the DV camera rewinds. Capturing begins automatically and ends
when the video tape ends.
Select any of the following commands:
To separate the video into smaller clips, select the Create clips when
wizard finishes check box.
To stop capturing before the end of the video tape, click Stop Capture, and
then click Yes in the resulting dialog box to save the video that has been
captured.
To close the Video Capture Wizard, click Finish.
The captured content is imported into a new collection with the same name as
the specified video file.
------------------------------------------------------------------------------------------------
But this window doesn't show "On the Capture Method page, click Capture the
entire tape automatically." That's the most important step and it doens show
up.... why? I'm using a Canon ZR20. Thanks everyone. I'm using version 2 of
WMM
------------------------------------------------------------------------------------------------
To capture the entire video from a tape in a DV camera
Make sure your DV device is connected properly to an IEEE 1394 port, and
then set the camera mode to play recorded video (often labeled VTR or VCR on
a DV camera).
On the File menu, click Capture Video.
–or-
In the Movie Tasks pane, under Capture Video, click Capture from video
device.
On the Video Capture Device page, in Available devices, click the DV camera.
In the Enter a file name for your captured video box, enter a file name for
your captured video file. Then, in the Choose a place to save your captured
video box, select the location where you want your video to be saved or click
Browse to select a location.
On the Video Setting page, choose the video setting you want to use for
capturing video and audio.
On the Capture Method page, click Capture the entire tape automatically.
The tape in the DV camera rewinds. Capturing begins automatically and ends
when the video tape ends.
Select any of the following commands:
To separate the video into smaller clips, select the Create clips when
wizard finishes check box.
To stop capturing before the end of the video tape, click Stop Capture, and
then click Yes in the resulting dialog box to save the video that has been
captured.
To close the Video Capture Wizard, click Finish.
The captured content is imported into a new collection with the same name as
the specified video file.
------------------------------------------------------------------------------------------------
But this window doesn't show "On the Capture Method page, click Capture the
entire tape automatically." That's the most important step and it doens show
up.... why? I'm using a Canon ZR20. Thanks everyone. I'm using version 2 of
WMM