Can this be done with Ghost 9?

  • Thread starter Thread starter Colonel Blip
  • Start date Start date
C

Colonel Blip

Hello, All!

I have an 80gb IDE drive. I am likely going to get a Raptor 36gb SATA drive.
The IDE is setup with 7 partitions, only 3 of which I intend to install on
the Raptor. They are about 26 gb total. If I setup the Raptor with 3
partitions, each of which will be slightly larger than the corresponding
partition on the IDE drive but none of which will be the same size as the
IDE partitions I want to copy onto it, is Ghost smart enough to copy the
images for each of the partitions to the new drive and not reduce the
available capacity of the Raptor partitions?

Thanks.

Colonel Blip.
E-mail: (e-mail address removed)
 
I have an 80gb IDE drive. I am likely going to get a Raptor
36gb SATA drive. The IDE is setup with 7 partitions, only
3 of which I intend to install on the Raptor. They are about
26 gb total. If I setup the Raptor with 3 partitions,
Click to expand...

You dont normally do it like that with modern cloning programs.

The usual way to do it is to clone the 3 partitions to the
new drive one at a time and specify the size of the copy
of each at setup time. You dont normally create the
partitions outside the program used to do the cloning.
each of which will be slightly larger than the corresponding
partition on the IDE drive but none of which will be the same
size as the IDE partitions I want to copy onto it, is Ghost
smart enough to copy the images for each of the partitions
Click to expand...

You dont actually have images in that situation.

You basically copy from the original partition
to the new one, partition by partition.
to the new drive and not reduce the
available capacity of the Raptor partitions?
Click to expand...

Yep.
 
Hello, Rod!
You wrote on Sat, 26 Feb 2005 05:39:03 +1100:

Thanks.

ColBlip.
E-mail: (e-mail address removed)


RS> Colonel Blip <[email protected]>
RS> wrote in message
??>> I have an 80gb IDE drive. I am likely going to get a Raptor
??>> 36gb SATA drive. The IDE is setup with 7 partitions, only
??>> 3 of which I intend to install on the Raptor. They are about
??>> 26 gb total. If I setup the Raptor with 3 partitions,

RS> You dont normally do it like that with modern cloning programs.

RS> The usual way to do it is to clone the 3 partitions to the
RS> new drive one at a time and specify the size of the copy
RS> of each at setup time. You dont normally create the
RS> partitions outside the program used to do the cloning.

??>> each of which will be slightly larger than the corresponding
??>> partition on the IDE drive but none of which will be the same
??>> size as the IDE partitions I want to copy onto it, is Ghost
??>> smart enough to copy the images for each of the partitions

RS> You dont actually have images in that situation.

RS> You basically copy from the original partition
RS> to the new one, partition by partition.

??>> to the new drive and not reduce the
??>> available capacity of the Raptor partitions?

RS> Yep.
 
Back
Top