cable tester error message

  • Thread starter Thread starter Mark M.
  • Start date Start date
M

Mark M.

Hi:

I just hardwired our LAN and now have a bit of a issue.
When I test the circuit it says "Connect, not parallel".
I followed the color sequence and it should be okay. The
is one thing though, I used the crimp jack connectores
and their color sequence is the reverse on 2 pairs of
wires. One is o-o/w and the other pair is b/w-b, where
the color scheme I followed shows this to be the
reverse. Any suggestions would be helpful.

Thanks Mark
 
Sounds like you might have made a Cross-over cable(for PC-PC direct),
instead of straight thru. PC-HUB,Switch or router) Make both ends the same.
 
Back
Top