C0000218 registry start up

  • Thread starter Thread starter Oscar J. Lutz
  • Start date Start date
O

Oscar J. Lutz

Dear Person:

My other computer does not boot up. Upon starting the MSN
2000 professional softerware, the C0000218 registry error
message pops up.

I have tried to start the computer in the F8 safe modes
(various ones listed) and have not been sucessful.

When running the diagnostic program, my computer showed 56
errors. All were in the read mode.

Please advise on how to proceed. Thank you, Oscar Lutz
 
You didn't mention the hive, if the software hive is corrupt, it may be
possible to rename the software hive found in;
%windir%\system32\config\software
to software.old
then copy the most recent backup found in
%windir%\repair\regback
as
%windir%\system32\config\software

If that fails you can copy/ use the file
%windir%\repair\software
This file is an image of the hive at the time the OS was installed, so you'd
have to reinstall all software. This being the case you might just as well
blow it away and start a new install. (note: this would at least allow you
to start the OS to make any necessary backups prior to wiping the drive.)

Else if the system hive, and assuming you already tried LKG, It may be
possible to rename the system hive found in
%windir%\system32\config\system
to system.old
then rename
%windir%\system32\config\system.alt
to
%windir%\system32\config\system

You can also try using the most recent backup found in
%windir%\repair\regback

If that fails you haven't much choice but to copy/ use the
original-as-installed system hive from
%windir%\repair\system
to
%windir%\system32\config\system
You'll need to reinstall the device drivers for any hardware added since the
original OS install.

To start the Recovery Console, start the computer from the Windows 2000
Setup CD or the Windows 2000 Setup floppy disks. If you do not have Setup
floppy disks and your computer cannot start from the Windows 2000 Setup CD,
use another Windows 2000-based computer to create the Setup floppy disks.
Press ENTER at the "Setup Notification" screen. Press R to repair a Windows
2000 installation, and then press C to use the Recovery Console. The
Recovery Console then prompts you for the administrator password. If you do
not have the correct password, Recovery Console does not allow access to the
computer. If an incorrect password is entered three times, the Recovery
Console quits and restarts the computer. Once the password has been
validated, you have full access to the Recovery Console, but limited access
to the hard disk. You can only access the following folders on your
computer: %systemroot% and %windir%
 
I tried your solution, because I had the same problem with my computer.
Unfortunately it didn't work. The only solution seems to be to reinstall
windows. However when I do that, after a couple of days the same error
occurs.

Do you have any idea on what to do now?

Jeroen Logtenberg
 
Back
Top