S
Steven
Modem works fine in NOT blind dailing mode under w2k.
However when ticking off the wait for dailtone before
dailing
(under start>Control Panel>Phone and modems
options>Modems>PCTEL 2304 WT V.92 MDC Properties>General)
and inserting x0 (blind dailing AT command see
http://support.ap.dell.com/docs/comm/r35323/en/at_and_s.htm
)
in the Extra initialisation commands
(under start>Control Panel>Phone and modems
options>Modems>PCTEL 2304 WT V.92 MDC Properties>Advanced)
a Windows Error 692: There was a hardware failure in
modem (or other connecting device) is seen.
Anybody intelligent out there who can shed some light on
this? Any suggestions are welcome
Steven
PS:The modem works fine in a hyperterminal blind dailing
session i.e. atx0dt1234
However when ticking off the wait for dailtone before
dailing
(under start>Control Panel>Phone and modems
options>Modems>PCTEL 2304 WT V.92 MDC Properties>General)
and inserting x0 (blind dailing AT command see
http://support.ap.dell.com/docs/comm/r35323/en/at_and_s.htm
)
in the Extra initialisation commands
(under start>Control Panel>Phone and modems
options>Modems>PCTEL 2304 WT V.92 MDC Properties>Advanced)
a Windows Error 692: There was a hardware failure in
modem (or other connecting device) is seen.
Anybody intelligent out there who can shed some light on
this? Any suggestions are welcome
Steven
PS:The modem works fine in a hyperterminal blind dailing
session i.e. atx0dt1234