Blank 2nd page

  • Thread starter Thread starter Guest
  • Start date Start date
I am getting blank 2nd page in my report, how to get
rid of it?

Thank you,
-M

The usual cause of blank pages in a report is that the combined width
of the report plus the width of the left and right margins is greater
than the width of the paper.
Either make the width of the report shorter or decrease the width of
the left and right margins, or both.

If you can't drag the right edge of the report towards the left you
probably have a control (usually a line) extending to the current
right position. It can be just at the extreme top or bottom of a
section which means it is going to be hard to see in Design View.
Use the Object drop-down control to highlight each line in turn until
you find the culprit. Reposition it or make it shorter, then drag the
right edge to the wanted size.

Another possible cause is the length of the report is too long. Make
the Top and Bottom margins smaller and make the length of the report
shorter.
 
Thank you Fred, you reply is on the dot.

-M

fredg said:
The usual cause of blank pages in a report is that the combined width
of the report plus the width of the left and right margins is greater
than the width of the paper.
Either make the width of the report shorter or decrease the width of
the left and right margins, or both.

If you can't drag the right edge of the report towards the left you
probably have a control (usually a line) extending to the current
right position. It can be just at the extreme top or bottom of a
section which means it is going to be hard to see in Design View.
Use the Object drop-down control to highlight each line in turn until
you find the culprit. Reposition it or make it shorter, then drag the
right edge to the wanted size.

Another possible cause is the length of the report is too long. Make
the Top and Bottom margins smaller and make the length of the report
shorter.
 
Back
Top