Belkin Wireless Network Access

  • Thread starter Thread starter Taishi
  • Start date Start date
T

Taishi

Help!

I'm having major problems with my Belkin Wireless Network Access
Point(F5D6130):

Lost wireless connection and tried the following:

Powered off/on AP
Reset and Powered Off/ON AP
Unable to ping the default ip in both cases. ip = 192.168.0.254

Attempted using the PING command and it fails. "Request Timed Out"

I have another PC connected to the network that I'm using to ping the AP.

Any ideas?

Thanks...

Additional info:
Your info is not enough.
like how far the unit is from the wireless access point?? 24 inches
Is your card installed properly. Was it working earlier? Yes.. but I'm
Click to expand...
trying to connect to it directly with a cable. No luck.
Did you ping your own pc??? Yes. And I was able to ping Yahoo.com and
Click to expand...
other computers on the network.
 
Make sure that all of your computers are on the same network.

ex: 192.168.1.0 all of the other computers must be on the same network
such as 192.168.1.x any thing other than 192.168.1.1
 
Both cases? An address can only apply to one location.
The default IP address for my Belkin WAP is 192.168.2.254. and this should
be set to DHCP >on on the Lan settings page. (WAP "homepage")
Your PC's IP addresses should then be set to obtain IP address
automatically. Go to Start>My Network places (right click>Properties)
Wireless connection, (right click >Properties) Internet Protocol
TCP/IP>properties.
HTH
MH
 
Back
Top