BDOD 0x0000007B Just after completing Flat Image Install, System u

  • Thread starter Thread starter sysbuilder
  • Start date Start date
S

sysbuilder

I am customizing a base install of Windows XP SP2 in a RIS environment. I am
doing this for a client system which utlilizes a SATA HDD interface. I have
integrated the the SATA drivers appropriately. Remote Installation sees the
drive and textmode and the guimode complete.

It's when the system cycles power for the first time after setup completion
(and over and over again) it gets to the splash screen and BSOD's on me with
an error code of 0x0000007B. There is no description below the STOP error.

I've researched the articles pointing to this error and I cannot think of
other issues beside having something to do with the SATA device drivers.
These are the latest drivers from the manufacturer as well.

Can someone point me in the right direction? Thanks.
 
"The latest drivers" dont always work with SATA/RAID controllers..Determine
SATA controller,if 2 or more years old,get the last drivers for it before the
mfg updated the hardware...
 
Thank you for the response, Andrew.

I've tested this with both driver versions available from the manufacturer
and I still have the same behavior with the blue screen.

I was able to locate an riprep image of the hardware i'm using from a
previous RIS environment and this image loads fine. Maybe this helps?
 
Back
Top