Antec "Sonata II" Chassis Air Guide, use with fans or not?

  • Thread starter Thread starter Ken Maltby
  • Start date Start date
K

Ken Maltby

Is there a big difference in the noise level of this case if
you install and run the two fans?

Luck;
Ken
 
Ken Maltby said:
Is there a big difference in the noise level of this case if
you install and run the two fans?
Click to expand...

I can't say that the 120mm fans provided by Antec are silent, but I have a
CoolerMaster case with a pair of 120mm fans. The PC is SILENT (unless I'm
gaming, then the video card fan winds up)

You want SLOW 120mm fans, so they move some air, but aren't audible. If your
fans aren't slow enough, you can do the 7 volt mod, or install a speed
controller.
 
Noozer said:
I can't say that the 120mm fans provided by Antec are silent, but I have a
CoolerMaster case with a pair of 120mm fans. The PC is SILENT (unless I'm
gaming, then the video card fan winds up)

You want SLOW 120mm fans, so they move some air, but aren't audible. If
your fans aren't slow enough, you can do the 7 volt mod, or install a
speed controller.
Click to expand...
The Sonata II has a 120mm three speed fan, with a mini switch to
set it at 2000 RPM or 1600 RPM or 1200 RPM.

The fans in the air duct are 80mm (over the vid card(s) ) and a 92mm
over the CPU area. I will probably be putting a fan controller on those.

Luck;
Ken
 
If anyone is following this, I ended up removing the fans I had
installed in the Air Guide.

I found another odd sound related issue with this case; when
I close the door over the drives and switches, all the way there
is a resonance setup by the air being drawn in around the door.
The noise disappears if I leave the door open about a 1/2 inch.

This is a great case though, and the power supply with two 12v
rails is very stable.

Luck;
Ken
 
Back
Top