AIW 9700 Pro

  • Thread starter Thread starter gus
  • Start date Start date
G

gus

I have an AIW 9700 Pro. Can I get this to display
satellite TV, by running coax from the satellite
receiver out to the CATV input on this card? (The
satellite receiver can output on Channel 3 or 4).

So far, when I do that, I get a message "no
signal" on the TV display, and the channel scan
gives no results. Is there a way I can tune the
card to receive channel 3 or 4 per above?
 
gus said:
I have an AIW 9700 Pro. Can I get this to display
satellite TV, by running coax from the satellite
receiver out to the CATV input on this card? (The
satellite receiver can output on Channel 3 or 4).

So far, when I do that, I get a message "no
signal" on the TV display, and the channel scan
gives no results. Is there a way I can tune the
card to receive channel 3 or 4 per above?
Click to expand...

You have to set the antenna input to antenna (not Cable) on the Settings >
TV Tuner page to receive channel 3/4.
The cable length should be less than 20 feet to avoid signal loss.
Satellite receiver must be on and tuned to a active channel before the tuner
setup will see it.
 
Back
Top