Advanced Configuration and Power Interface

  • Thread starter Thread starter Guest
  • Start date Start date
G

Guest

Hi,

I have a problem while trying to run a depednency check in Target Designer.
I get an error message that Advanced Configuration and Power Interface has
experienced an activation failure. Previously, it was in conflict with the
Standard PC component, which I removed. However, the issue is there still,
and I think there may be other conflicitng devices related to ACPI or
Standard PC...

Any help in the matter would be appreciated. Thanks. :)
 
Bing.Chen said:
Dear Compudata,

Please check the log file to know which component depends on Standard
PC.

You just need to disable or remove it and this problem is overcome.

--
Best Regards,
Bing Chen
Advantech Co., Ltd.
Microsoft eMVP

¬ãµØ - ·L³nÂ¥xÆW°Ã´O¤J¦¡§@·~¨t²Î¸g¾P°Ó
http://www.advantech.com.tw/epc/newsletter/ATW/2005MS/
Click to expand...

Hm, I'll try that...I did it in the configuration list in Target Analyzer,
but never tried looking in the log file...once again, thanks for the feedbacl
:)
 
Back
Top