ADH FormResize

  • Thread starter Thread starter Margaret Dullnig via AccessMonster.com
  • Start date Start date
M

Margaret Dullnig via AccessMonster.com

I sent this question to Sybex, but they say their support does not cover
it. I hope someone here can help.

I am trying to use the FormResize class. I have included the
specified code in Form_Open. This is the screenInfo results: Call
frmResize.SetDesignCoords(1152, 832, 120, 120). I exit access, then
change my resolution to 1024x768. When I go back into Access, the
detail section of the form is partially cutoff (at the bottom). I am
using header, footer, and detail sections. My form and controls are
all unbound (using ADO). I have autocenter turned off. Any ideas
what might be wrong?

Thanks,
Peg
 
Thanks, but I went to http://www.developershandbook.com/, searched for
answers and sent an email asking for help. I have not received a response.

It seems from other posts that it is difficult to design in a higher
resolution for use in a lower resolution. Would using the "tag" feature of
the resize software be a solution? It just seems that the Detail section
of the form is not being enlarged to display all the controls. Maybe I need
to explicitly enlarge the detail section?

Any help is appreciated.
 
Back
Top