Access is printing blank pages between reports

  • Thread starter Thread starter Guest
  • Start date Start date
G

Guest

I am not sure where to look in report design view to check that the controls
are not extending beyond the printable width of the paper. I am experiencing
a blank page between reports when I run a report. This problem just occurred
last week and I am not able to correct it.
 
Terry:

Some general comments. Look at the width of the report, the margins, and
the page orientation. For example, if the orientation is portrait, then the
sum of the visible report width plus the left and right margins must not
exceed 8.5 inches. You can decrease the visible report by dragging over the
right edge of the report. If there are controls near the edge, you will not
be able to decrease the width beyond those controls. You will have to move
the controls in question before you can decrease the width of the report
further.

The same goes for a landscape report except the total width must be less
than 11 inches.


--
David Lloyd
MCSD .NET
http://LemingtonConsulting.com

This response is supplied "as is" without any representations or warranties.


I am not sure where to look in report design view to check that the controls
are not extending beyond the printable width of the paper. I am
experiencing
a blank page between reports when I run a report. This problem just
occurred
last week and I am not able to correct it.
 
Back
Top