About harddisk power led

  • Thread starter Thread starter Jacky Luk
  • Start date Start date
J

Jacky Luk

OT:)
My original case provides 3-pin power led to motherboard, but my motherboard
just got 2 pins.
With Vcc on left side and Signal on the right side on my motherboard, the
case provides 3-pin, with Vcc on the left, GND in the middle and signal on
right, those two pairs won't match, but does anyone have a workaround so
that the power led can be turned on again.... Thanks
Jack
(3-pin from case) (motherboard)
_ Signal - Signal
_ Gnd - Vcc
_ Vcc
 
Hi

Find the common ground point somewhere from the mobo

Pete


----- Jacky Luk wrote: ----

OT:
My original case provides 3-pin power led to motherboard, but my motherboar
just got 2 pins
With Vcc on left side and Signal on the right side on my motherboard, th
case provides 3-pin, with Vcc on the left, GND in the middle and signal o
right, those two pairs won't match, but does anyone have a workaround s
that the power led can be turned on again.... Thank
Jac
(3-pin from case) (motherboard
_ Signal - Signa
_ Gnd - Vc
_ Vc
 
Look at the 3 pin connector closely, you should be able to use a pin or
something small like that to release the lock tabs on the terminals and slip
them out the back then reinsert how you want them. I advise you to look
closer at the motherboards power led pinout. The one you mentioned is not
standard.
 
Back
Top