S
sdlomi
New build using A7N8X ver. 2.0 & running XP Pro. When I try to play
sounds-- cd, harddrive, or bootup, I get no sound. When trying songs on hd,
or cd's, get message on WinMedPlayer that "Cannot playback audio stream. No
audio hardware available or not responding."
All devices in device driver show working correctly.
Special circumstances caused me to 'cable' as follows: IDE1: h/d-1 as pri.
master & h/d2 as pri. slave. IDE2: cd-rw as sec. master & cd-rom as
sec.slave.
To set up from start, I used IDE1 with hd1 as pri. master and cdrom as
pri. slave--and nothing on IDE2. Then recabled to above configuration. (I
had lots of info on hd 2 whose mobo went bad on another system--hence the
motive to make it slave off hd1 in new system. It would not boot just
installing hd1, full of info, as pri. master in new system.)
HELP! All suggestions welcome. sdlomi
BTW: The XP2100, w/128mg generic 2100DDR, runs fine otherwise at 13X166,
XP2600 I guess.. Tried no other settings yet.
sounds-- cd, harddrive, or bootup, I get no sound. When trying songs on hd,
or cd's, get message on WinMedPlayer that "Cannot playback audio stream. No
audio hardware available or not responding."
All devices in device driver show working correctly.
Special circumstances caused me to 'cable' as follows: IDE1: h/d-1 as pri.
master & h/d2 as pri. slave. IDE2: cd-rw as sec. master & cd-rom as
sec.slave.
To set up from start, I used IDE1 with hd1 as pri. master and cdrom as
pri. slave--and nothing on IDE2. Then recabled to above configuration. (I
had lots of info on hd 2 whose mobo went bad on another system--hence the
motive to make it slave off hd1 in new system. It would not boot just
installing hd1, full of info, as pri. master in new system.)
HELP! All suggestions welcome. sdlomi
BTW: The XP2100, w/128mg generic 2100DDR, runs fine otherwise at 13X166,
XP2600 I guess.. Tried no other settings yet.