9600SE to DVI

  • Thread starter Thread starter Redbird
  • Start date Start date
R

Redbird

I just got a monitor that has dvi on it.
When I hook it up to the DVI on the card then WinXP Pro will not boot.
I go back to the analog and it boots.
I had the 3.9 drivers on when I did this.
Any ideas?

Thanks...
 
I just got a monitor that has dvi on it.
When I hook it up to the DVI on the card then WinXP Pro will not boot.
I go back to the analog and it boots.
I had the 3.9 drivers on when I did this.
Click to expand...

I take it you see the bood BIOS messages, so be sure to enable DVI output:
Right click Desktop>Properties>Settings>Advanced>Displays. Now, look for I/O
(I in O) symbol in FPD lower right display, and click on.

-Kent
 
When I first hooked it up, it booted up and I was in there at FPD and
that was on. I made sure the settings were ok so I wanted to reboot to
save my settings and come back on. Well it would not reboot after
that. So I put the anolog cable on to get running again. That is where
I'm at now. After I got back up I took the 3.9 drivers off and put 4.1
drivers on and have not tried the DVI on the new drivers.

Thanks...
 
Back
Top