300GB HDD - Serious Errors

  • Thread starter Thread starter Guest
  • Start date Start date
G

Guest

After installing XP, my 300GB SATA hard drive wont read above 127GB. I found
out that the XP Service Packs 1 & 2 must be installed, then you have to
extend the partition to read the full drive's size.

I did this, which worked, but now my PC constantly resets for no apparent
reason.

These are the errors Im getting:

*** STOP: 0X0000008E (0XC000001D, 0X8058042C, 0XB6EC6C90, 0X00000000)
and
*** STOP: 0X0000008E (0XC000001D, 0X8058042C, 0XB6765C90, 0X00000000)
and
*** STOP: 0X00000050 (0XFFB3B4E0, 0X00000000, 0X804EAF9F, 0X00000000)
and
PAGE_FAULT_IN_NONPAGED_AREA
*** STOP: 0X0000008E (0XC000001D, 0X8058042C, 0XB6E66C90, 0X00000000)


Which results in the "The system has recovered from a serious error" message
after reboot, which contains the following:

BCCODE: 1000008e BCP1: c000001d BCP2: 8058042c BCP3: B6EC6C90 BCP4: 00000000
OSVer: 5_1_2600 SP: 2_0 Product: 768_1
 
If you haven't installed anything else on the SATA drive I would slipstream
your original XP CD with SP2, create a new disk and reformat using the new
disk. This will allow the whole 300GB to be available to XP and that should
cure the problem assuming no hardware faults.

Neil
 
Back
Top